- Product Details
-
It is important that spillages or leaks in mechanical rooms are contained. Water or chemicals from a burst pipe or leaking tank could cause damage if it seeps through joints or cracks to rooms beneath. Watco Mechanical Room Coating is a High build, matte, lightly textured coating which provides seamless, flexible protection, filling and bridging joints and cracks
- Thick and flexible waterproof coating
- Excellent adhesion
- Fills and seals cracks in floors
- Non-toxic – suitable for use near drinking water
Coverage: 130ft² per pack at 40mil thick. One coat usually sufficient
Quick Links
Technical Data Sheet
Blue Safety Data Sheet
Buff Safety Data Sheet
Green Safety Data Sheet
Navy Safety Data Sheet
Off White Safety Data Sheet
Tile Red Safety Data Sheet
- Specifications
-
Delivery Time (Days) Ships in 24 hours, delivers in 1-3 days Usage - Interior / Exterior interior Usage - Suitable for plant rooms, or any areas where spillage needs to be contained Usage - Surfaces concrete, brickwork, stone, masonry, plaster Coverage (sqft per kit) 0.5² Application - Curing Time (hours) light traffic: 16 hours at 15-20°C. Heavy traffic: 3 days at 15-20°C Application - Recommended Coats 2 Coats - How To Apply
-
Preparation
Surfaces must be cleaned of all grease, dust, cement laitance and other contaminants. Dampen surfaces with clean, cold water. A minimum air and surface temperature of 40°F is essential.
Mixing
Place the powder into the bucket along with the small bag of pigment (if using the colored version) and pour in approximately three quarters of the Watco Mechanical Room Coating liquid, mix using a slow speed drill and paddle mixer. Mix for approximately 3 minutes until a lump free, creamy consistency is achieved. Add the remaining liquid and mix thoroughly..
Application
Application can be made by roller, trowel, or squeegee depending upon the finish required. The coating should be applied at approximately 40mil thick. If a second coat is required it can be applied as soon as the first is cured, normally 12-24 hours.
Curing
At 60-70°F a floor treated with Watco Plant Room Coating can take light traffic after approximately 16 hours and heavy traffic after 3 days. Full chemical curing is achieved over 7 days. It is at this point the coating will resist permanent water pressure.
Pot Life
2 hours at 60°F 1.5 hours at 70°F 30 mins at 85°F - Reviews
-
- Request a Quote/Sample
-
You might also need...
-
Paint Rolling Supplies Kit
$119.50 excl. tax
-