- Product Details
Watco Resiflow Super Gloss has all the benefits of Watco Resiflow but with a high gloss finish, making it ideal for showrooms, reception areas, galleries or shops. Extremely easy to keep clean due to the superior finish, it is also ideal for floors where high levels of hygiene are important. The gloss levels are the highest of any of our screeds, giving an exceptional mirror finish to the floor.
- Seamless, smooth gloss finish
- 100% solids epoxy formula
- Use primer: For smooth floors use Powerfloat Primer For porous floors use 4 Hour Epoxy Primer
- Exceptional wear resistance
Coverage: 50-100ft² per 44lb pack
- Specifications + Technical Data Sheets
Delivery Time (Days) Ships in 24 hours, delivers in 1-3 days Usage - Interior / Exterior Interior Usage - Suitable for Floors in processing and manufacturing plants, wet areas, workshops, showrooms etc. Usage - Properties Seamless, smooth gloss finish, water based formula, no primer needed, exceptional wear resistance Usage - Surfaces Concrete, brick and steel Coverage (sqft per kit) 50-100ft² per 44lb pack Application - Curing Time (hours) 24 hours at 60-70°F Application - Pot Life (hours) 30-40 minutes at 60°F Application - Recommended Coats one coat is usually sufficient
- How To Apply
Concrete and brickConcrete to be treated must be dry, at least four weeks old and free of any soft surface laitance, contaminants, and not subject to rising damp. All loose material should be removed. Very smooth bare concrete or concrete with soft surface laitance should be etched with Watco Cemtetch and the area thoroughly hosed off and allowed to dry. Grease or oil should be removed with Watco Bio-D (or similar degreaser) and the area thoroughly hosed off and allowed to dry. Very smooth previously painted surface should preferably be abraded to improve adhesion.
SteelRemove loose or flaking material, rust and any previous coatings by wire brushing or disc grinding to achieve a bright surface. Grease or oil should be removed with Watco Bio-D and the metal then washed with water and allowed to dry. Coating should be carried out immediately providing flash rusting has not occurred. Resiflow Supergloss should only be laid at floor surface temperatures between 60°F and 95°F.
Remove all components from the outer bucket. Pour the contents of the resin tin into the bucket. Using a mixing blade (available from Watco) fitted to a slow speed electric drill, start to mix while slowly adding the curing agent. Scrape around the inside of both tins to ensure all the material has been removed. When thoroughly mixed add the fine aggregate component steadily until uniform in colour and consistency and continue blending for a further 5 minutes, ensuring that all material at the sides and base are thoroughly mixed. It is possible to hand mix small quantities but great care must be taken.
If appearance is critical we recommend the application of a small trial area first.
Working in sections of approximately 16 feet, pour the mixed Resiflow Super Gloss on to the prepared surface and spread evenly to the desired depth of 40-80mil thick using a Watco Resiflow Applicator or similar notched squeegee. Within approximately 5-10 minutes, apply a spiked roller to remove air bubbles. Repeat a few minutes later and thereafter until air bubbles cease. Spike rollering should extend into the previously applied section, but ensure that this has not hardened to such a degree that spiked rollering is not possible. If a knife cut in the wet surface heals quickly, the surface is still safe to roller. Spiked shoes (available from Watco) are recommended to enable operators to reach all areas of the uncured floor.
- Request a Quote/Sample