Basket (0)

Watco manufactures industrial strength floor paints, repair materials and non slip products

Powerfloat Sealer

Powerfloat Sealer

$132.30  excl. tax

Seal concrete floors and protect smooth or powerfloated concrete with Watco Powerfloat Sealer. One coat seals, dustproofs and protects floors in busy, heavy traffic areas.

Add Items to Cart
VIEW PRICE BREAKS
  • Buy 1 for $132.30  excl. tax each
  • Buy 5 for $125.68  excl. tax each and save 5 %
 
Product Details
Watco Powerfloat Sealer is specially designed for very smooth, hard, powerfloated concrete floors. Such surfaces should usually be shotblasted or ground to provide a key, but this unique epoxy resin formulation can be simply applied by roller directly to the smooth surface. Removing the need for blasting or texturing means the attractive smooth surface of the concrete is maintained and costly shotblasting work is avoided. One coat seals, dustproofs and protects.

  • Coverage: 320ft² in one layer. A single layer is generally sufficient. However, two coats may be necessary on a porous ground.
  • Drying time: 16 hours at 60-70°F for heavy traffic

    Pendulum Slip Test Values for A/S version
    Dry PTV
    Wet PTV
     69 Extremely low slip potential  56 Low slip potential 


    Quick Links

    Technical Data Sheet
    Safety Data Sheet
  • Specifications
    Delivery Time (Days) Ships in 24 hours, delivers in 1-3 days
    Usage - Interior / Exterior interior or exterior
    Usage - Suitable for powerfloated or very smooth concrete
    Usage - Properties two pack epoxy resin supplied as a 1.3 gallon
    Usage - Surfaces concrete floors
    Coverage (sqft per kit) approximately 30m² per 5 litre per coat
    Application - Curing Time (hours) 16 hours at 15-20°C
    Application - Pot Life (hours) 2 hours at 20°C
    Application - Recommended Coats 1
    How To Apply
    Surface Preparation
    New concrete should be allowed at least 28 days to dry. Surfaces should be clean, dry and free from oil, grease, dust, dirt and other contaminants. Existing coatings should be well bonded and sound.

    Mixing
    The tall outer tin contains a tin of Resin and a tin of Curing Agent. Remove these two tins and stir the contents of each thoroughly. Decant both tins into the tall outer tin. The two components should then be very thoroughly mixed together using a wide bladed stirrer. Mix for 2-3 minutes until an even consistency is obtained. Both liquids are opaque white/off white in color and it is important to ensure complete mixing to allow the cure reaction to happen.

    Application
    Decant the mixed components into a roller tray and apply using a medium pile type roller. A brush may be used for cutting in. Aim to apply the mixed components within one hour (they are useable for up to 2 hours maximum at 70°F). Do not apply at temperatures below 50°F or above 85°F. Cold or damp conditions may prevent full curing. Avoid applying too thick. The two components for Powerfloat Sealer are white, but the coating will cure to a clear finish within 2 hours.
    Reviews
    Request a Quote/Sample
    Delivery

    Home Delivery

    Shipping cost

    Over $1,250.00 FREE
    From $750.00 to $1,249.99 $49.00
    From $400.00 to $749.99 $39.00
    From $100.00 to $399.99 $32.00
    Up to $99.99 $19.50

    © 2017 Watco Industrial Flooring. All Rights Reserved.



    Terms & conditions |  Privacy policy |  Site map |  About us