- Product Details
Watco Cold Set Coating uses the latest polyaspartic resin technology to provide a high quality, highly wear resistant coating that can be applied at low temperatures. It is ideal for refurbishment and maintenance in unheated areas during the winter months when conventional coatings will fail to dry.
It has exceptional UV resistance makes it ideal for exterior application as it resists chalking, weather and fading.
Uses: refurbishment and maintenance in unheated areas. As a coating in walk-in fridges, cold stores and loading bays.
- Withstands heavy wear and tear
- Excellent chemical resistance
- Can be applied between 14°F and 85°F
- Fast curing
Coverage approx 270 sq ft per pack; onto a non-porous surface or 100 - 160 sq ft; onto a porous or textured surface. Coverage will be reduced if surface is porous or textured, or if applying at temperatures below 32°F.
Technical Data Sheet
Cold Set Coating Green Safety Data Sheet Cold Set Coating Blue Safety Data Sheet
Cold Set Coating Tile Red Safety Data Sheet
Cold Set Coating Silver Gray Safety Data Sheet
Cold Set Coating Navy Gray Safety Data Sheet
- Specifications + Technical Data Sheets
Appearance Matte Delivery Time (Days) Ships in 24 hours, delivers in 1-3 days Usage - Interior / Exterior Interior and Exterior Usage - Suitable for walk in fridges and freezers, cold stores, loading bays and exterior areas Usage - Properties cures at 14°F Usage - Surfaces concrete Max Operational Temp (deg F) 85°F Coverage (sqft per kit) 270 sq ft per pack on a non-porous surface, 100-160 sq ft per pack on a porous surface Application - Curing Time (hours) Ready for foot traffic in 18 hours at 41°F, 24 hours at 32°F Application - Pot Life (hours) 25-30 minutes at 60°F Application - Recommended Coats 2
- How To Apply
All the surfaces must be 14°F or above and free from ice or water. The concrete to be treated must be at least four weeks old, completely dry and free of contaminants. Grease or oil should be removed with Watco Bio D (or a similar emulsifying degreasant) and the area thoroughly washed off and allowed to dry.
Very smooth concrete or concrete with surface laitance (a weak dusty layer) should be abraded or etched with Watco Cemtetch to ensure adequate adhesion. The concrete should be thoroughly washed down and allowed to dry after treatment with Watco Cemtetch.
Watco Powerfloat Primer is recommended on power floated surfaces but it must be fully cured before overcoating. Previously painted surfaces should be thoroughly abraded by sanding to improve adhesion and to remove any weak or loose material. A trial area is advisable to test compatibility with previous coatings.
Below 41°F it may be necessary to avoid processes which involve wetting the floor due to the difficulty in drying. A good sweep or mechanical brushing may be sufficient. Do not apply outside if rainfall is imminent.
Only mix in temperatures between 50°F and 75°F. Remove the two inner tins from the tall outer tin. Stir each tin thoroughly and pour all of the contents into the outer tin (scrape around the inside of the tins to remove any residue). Mix the components together thoroughly using a spatula or a similar wide bladed tool (a piece of wooden batten is ideal). Continue mixing until an even color and consistency are obtained. Do not mix more than one pack at a time. If a paint stirrer fitted to an electric drill is used, also use the spatula to blend in any unmixed material from the sides and bottom of the tin. Do not dilute.
If appearance is critical we recommend the application of a small trial area first.
Only apply in temperatures between 14°F and 85°F. The viscosity will be somewhat thicker at very low temperatures, slightly reducing coverage.
- Request a Quote/Sample
You might also need...
$138.40 excl. tax